|
|
| Line 66: |
Line 66: |
| <br> | | <br> |
|
| |
|
| == Mixers ==
| | <br> |
| General Guidelines
| |
|
| |
|
| === Model I and Classic ===
| | {{:Mixer}} |
|
| |
|
| ===== XLR to XLR ===== | | === Specific Mixers === |
|
| |
|
| The XLR inputs for Channels 1 and 2 are intended for microphone level inputs. <br>
| | There are several articles related to using specific mixers with the {{Model I}} and {{Classic}}. Here is a list of what is available: [[Mixer|Mixers and connection recommendations]]<br> <br> |
| | |
| *If your source (mixer or CD/DVD player) has XLR outputs, check to see if you have the option to set it to a microphone level output. If so, use that setting.<br>
| |
| *If your source has XLR outputs at line-level (most likely) then you will probably need a [[Pad]] between the source and the [[Model I nl]] (or [[Classic nl]]) Power Stand. <br>
| |
| *You may be able to make things work without the [[Pad]] by turning down the output from the source and turning down the trim at the Power Stand. If it sounds okay then you are probably fine. If you cannot get enough a good sounding signal without an excess of noise then try a [[Pad]].
| |
| | |
| ===== ¼ inch jack inch to ¼ inch =====
| |
|
| |
|
| If your mixer has ¼ inch jack outputs, these are almost certainly at line-level and should work well with any of the ¼ inch jack inputs (Channels 1, 2, 3, 4) on a {{Model I}} or {{Classic}}.
| |
|
| |
|
| |
| === {{Model II}} ===
| |
|
| |
| {{#lst:L1® Model II|Stereo Source to Power Stand Analog Input}}
| |
|
| |
| === {{T1}} ===
| |
| You can probably run XLR or ¼ inch jack line level inputs to the T1® Channels 1,2,3. If you have the option to run ¼ inch to ¼ inch, you could use T1® Channels 4/5.
| |
| <br>
| |
|
| |
| === Specific Mixers ===
| |
| There are several articles related to using specific mixers with the {{Model I}} and {{Classic}}. Here is a list of what is available: [[Mixer|Mixers and connection recommendations]]<br> <br>
| |
| ---- | | ---- |
|
| |
|