Connections / DJ VJ Computer to Model I: Difference between revisions
m tabletoc |
== Signal/OL setting == |
||
| Line 31: | Line 31: | ||
For this kind of application the R1 Remote is recommended especially if you want overall control of volume and tone in one handy place. If your device does this well you may not need the R1 Remote. | For this kind of application the R1 Remote is recommended especially if you want overall control of volume and tone in one handy place. If your device does this well you may not need the R1 Remote. | ||
== Signal/OL setting == | |||
<linkedimage> | |||
wikipage=Model I | |||
tooltip=Setting the Trim | |||
img_src=SignalOLLED.png | |||
img_width=138px | |||
img_alt=Setting the Trim | |||
</linkedimage> | |||
== Mono Output from Device to Mono | * Set the [[R1 Remote]] Master Level all the way off. Set everything else pointed straight up. | ||
* Set you Mixer or Console to the highest output you are likely to use. | |||
* Connect the Console or Mixer to Power Stand Channel 1 | |||
* Set the Power Stand Channel 1 Trim so that the Signal/OL light is solidly green with occasional flickers of red. | |||
* Turn up the R1 Remote Master to set the overall volume, or turn down the output on the Mixer or Console, and turn up the R1 Remote Master Level so that it is pointed straight up. | |||
* Turn up the output level on the Mixer or Console to the desired volume. | |||
== Mono Output from Device to Mono L1® == | |||
If your device can output mono, then the connection is very simple. Run your mono output to Channel 2 or 3 or 4. | If your device can output mono, then the connection is very simple. Run your mono output to Channel 2 or 3 or 4. | ||
| Line 50: | Line 67: | ||
[[Image:Console01b.jpg]] | [[Image:Console01b.jpg]] | ||
== Stereo Output to Stereo | == Stereo Output to Stereo L1®s == | ||
Two | Two L1®s will provide an excellent stereo image over a very wide "sweet spot". | ||
[[Image:Console01d.jpg]] | [[Image:Console01d.jpg]] | ||
| Line 57: | Line 74: | ||
Use the same settings for both L1™s | Use the same settings for both L1™s | ||
* Input Trim | * Input Trim | ||
* Preset | * Preset (probably 57 or 58) | ||