L1® System FAQ: Difference between revisions
transcluded Model I FAQ from {{:L1® Model I / FAQ}} |
m Missing Model II Question Fixed |
||
| Line 127: | Line 127: | ||
=== What's the proper method for setting the gain on a Model II power stand when connected to an analog source? === | === What's the proper method for setting the gain on a Model II power stand when connected to an analog source? === | ||
While playing your instrument or audio source as loudly as you would in performance, adjust the trim level on the power stand until you see the LED go from yellow to red. Then back the trim level off until the signal LED is predominantly yellow with brief peaks into red. | While playing your instrument or audio source as loudly as you would in performance, adjust the trim level on the power stand until you see the LED go from yellow to red. Then back the trim level off until the signal LED is predominantly yellow with brief peaks into red. | ||
===What's the proper method for setting the gain on a Model II power stand when connected to a T1 ToneMatch audio engine? === | |||
Set the output volume of your source to normal operating volume. Make sure the master volume and channel volume on the ToneMatch audio engine are set to 0. While playing your instrument or audio source as loudly as you would in performance, turn the appropriate channel's trim control clockwise until the signal/clip indicator glows green or yellow. If the indicator flashes red or glows steady red, turn the trim control counterclockwise to decrease the level. | |||
== {{T1}} == | == {{T1}} == | ||