T1 ToneMatch® Audio Engine / Aux: Difference between revisions
m added citations |
m fixed citations |
||
| Line 1: | Line 1: | ||
The output of any of the Channels 1, 2, 3, 4/5 can be sent to the Aux out. Tap points where you can set the output to the Aux.<ref>Aux Tap Points from page | The output of any of the Channels 1, 2, 3, 4/5 can be sent to the Aux out. Tap points where you can set the output to the Aux.<ref name="AuxTap">Aux Tap Points from page 26 of the {{T1 Manual}}</ref> | ||
* Dry: After Preamp: The completely dry (no processing) signal is routed directly from the preamp stage. | * Dry: After Preamp: The completely dry (no processing) signal is routed directly from the preamp stage. | ||
| Line 21: | Line 21: | ||
What To Do: | What To Do: | ||
* Check if the Aux output is configured for the desired tap point for each input channel. Refer to “Routing input signals to the Aux output” on page 26.<ref>Routing input signals to the Aux output on page 26 of {{T1 Manual}}</ref> | * Check if the Aux output is configured for the desired tap point for each input channel. Refer to “Routing input signals to the Aux output” on page 26.<ref name="AuxTap">Routing input signals to the Aux output on page 26 of {{T1 Manual}}</ref> | ||
Note: No reverb comes from the Aux output even if the tap point is Pre or Post. | Note: No reverb comes from the Aux output even if the tap point is Pre or Post. | ||