Template:L1 Pro FAQ: Difference between revisions
Created page with "{{FAQList | content = {{FAQItem |question = What are the mid-high array and lower mid-high array made from? Metal mesh front and is rear metal or plastic? |answer..." |
mNo edit summary |
||
| Line 30: | Line 30: | ||
However, using XLR to XLR connections can lead to problems. | However, using XLR to XLR connections can lead to problems. | ||
{{FAQItem | |||
'''1. Some mixers can output mic‑level on XLR — most cannot''' | |question = '''1. Some mixers can output mic‑level on XLR — most cannot''' | ||
If your mixer allows switching its XLR outputs from Line to Mic, then it may work. | |answer = If your mixer allows switching its XLR outputs from Line to Mic, then it may work. | ||
But this is uncommon. | But this is uncommon. | ||
Using XLR → ¼″ (6.3 mm) Tip‑Ring‑Sleeve into Channel 3 is far more reliable. | Using XLR → ¼″ (6.3 mm) Tip‑Ring‑Sleeve into Channel 3 is far more reliable. | ||
}} | |||
'''2. Most mixer XLR outputs are line‑level, which is a poor match for the L1 Pro’s mic‑level XLR inputs''' | {{FAQItem | ||
|question = '''2. Most mixer XLR outputs are line‑level, which is a poor match for the L1 Pro’s mic‑level XLR inputs''' | |||
|answer = | |||
This mismatch can cause: | This mismatch can cause: | ||
* Input clipping | * Input clipping | ||
* Harsh distortion | * Harsh distortion | ||
* Unpredictable behavior | * Unpredictable behavior | ||
}} | |||
'''3. You can sometimes “make it work,” but it’s not ideal''' | {{FAQItem | ||
|question = '''3. You can sometimes “make it work,” but it’s not ideal''' | |||
|answer = | |||
You might avoid clipping by: | You might avoid clipping by: | ||
* Turning down the mixer output | * Turning down the mixer output | ||
* Turning down the L1 Pro channel volume | * Turning down the L1 Pro channel volume | ||
However: | However: | ||
* Lowering the mixer output reduces signal‑to‑noise ratio (more hiss) | * Lowering the mixer output reduces signal‑to‑noise ratio (more hiss) | ||
* Turning the L1 Pro channel knob very low gives almost no usable range | * Turning the L1 Pro channel knob very low gives almost no usable range | ||
* Volume may jump from too quiet → too loud with tiny adjustments | * Volume may jump from too quiet → too loud with tiny adjustments | ||
}} | |||
'''4. Channel 3 avoids all of these issues''' | {{FAQItem | ||
|question = '''4. Channel 3 avoids all of these issues''' | |||
|answer = | |||
Channel 3 is designed for line‑level sources and provides: | Channel 3 is designed for line‑level sources and provides: | ||
* Proper level matching | * Proper level matching | ||
| Line 65: | Line 71: | ||
''Mixer mono out → XLR‑to‑Tip‑Ring‑Sleeve → L1 Pro Channel 3'' | ''Mixer mono out → XLR‑to‑Tip‑Ring‑Sleeve → L1 Pro Channel 3'' | ||
}} | }} | ||
}} | |||
}} | }} | ||