L1 Pro to S1 Pro+: Difference between revisions

Line 3:

#Use an XLR female to 1/4 inch (6.3 mm) Tip-Ring-Sleeve to connect the L1 Pro Line Out to the {{S1 Pro+}} input three. You can also connect to channels 1 or 2, but using channel 3 is preferred because this gives the best match to the output level of the L1 Pro.

#* Note: The L1 Pro Line Output (XLR) is LINE LEVEL, so connect it to one of the S1 Pro 1/4 inch (6.3 mm) inputs. These are also LINE LEVEL.

#* Note: The L1 Pro Line Output (XLR) is LINE LEVEL, so connect it to one of the {{S1 Pro+}} 1/4 inch (6.3 mm) inputs. These are also LINE LEVEL.

#* The S1 Pro XLR inputs are MICROPHONE LEVEL, and the L1 Pro LINE LEVEL output may be too hot for the XLR inputs. ~~See~~ the ~~picture at~~ the ~~bottom of this article for details~~.

#* The S1 Pro XLR inputs are MICROPHONE LEVEL, and the L1 Pro LINE LEVEL output may be too hot for the XLR inputs. If the {{S1 Pro+}} input is clipping (RED LED), turn down the channel volume.

#Set the volume on the {{S1 Pro+}} to 10:00 o'clock and then adjust it to suit the application. If you see solid red on the {{S1 Pro+}}, turn down the channel volume.

@@ Line 3: / Line 3: @@
 #Use an XLR female to 1/4 inch (6.3 mm) Tip-Ring-Sleeve to connect the L1 Pro Line Out to the {{S1 Pro+}} input three. You can also connect to channels 1 or 2, but using channel 3 is preferred because this gives the best match to the output level of the L1 Pro.
-#* Note: The L1 Pro Line Output (XLR) is LINE LEVEL, so connect it to one of the S1 Pro 1/4 inch (6.3 mm) inputs. These are also LINE LEVEL.
+#* Note: The L1 Pro Line Output (XLR) is LINE LEVEL, so connect it to one of the {{S1 Pro+}} 1/4 inch (6.3 mm) inputs. These are also LINE LEVEL.
-#* The S1 Pro XLR inputs are MICROPHONE LEVEL, and the L1 Pro LINE LEVEL output may be too hot for the XLR inputs. See the picture at the bottom of this article for details.
+#* The S1 Pro XLR inputs are MICROPHONE LEVEL, and the L1 Pro LINE LEVEL output may be too hot for the XLR inputs. If the {{S1 Pro+}} input is clipping (RED LED), turn down the channel volume.
 #Set the volume on the {{S1 Pro+}} to 10:00 o'clock and then adjust it to suit the application. If you see solid red on the {{S1 Pro+}}, turn down the channel volume.