Template:ToneMatch Power Supply: Difference between revisions

@@ Line 14: / Line 14: @@
 See: [[T1 ToneMatch® Audio Engine / Connections to Model II|Connecting Two T1®s to a Model II]] for details.
 ----
-Close up of the connector that goes to the {{ToneMatch Mixer}}, just in case you damage the cable and have to replace the connector.
+If you disassemble the Ethercon connector (not recommended), it's tricky to reassemble it.
+[[File:NE8MX-B-1.jpg]]
-Note:  The picture is taken with the flat side facing the camera. The release clip is on the other side.
+Note: There are small guides on the grey piece that slide into the slots in the barrel.
-[[Image:T1 Power Supply RJ 45 Connector.jpg|400px|Close up of the RJ45 connector]]
+[[File:NE8MX-B-12.jpg]]
-[[File:NE8MX-B-1.jpg]]
+[[Media:BDA 564 - etherCON NE8MX-1 & NE8MX-B-1 - RJ45 cable connector carrier.pdf]]
+----
+Close up of the connector that goes to the {{ToneMatch Mixer}}, just in case you damage the cable and have to replace the connector.
+Note:  The picture is taken with the flat side facing the camera. The release clip is on the other side.
-[[Media:BDA 564 - etherCON NE8MX-1 & NE8MX-B-1 - RJ45 cable connector carrier.pdf]]
+[[Image:T1 Power Supply RJ 45 Connector.jpg|400px|Close up of the RJ45 connector]]
@@ Line 33: / Line 40: @@
 [[Category:T1]]
+[[Category:T4S]]
+[[Category:T8S]]
+[[Category:Connections]]
 [[Category:Bose Link]]