T4S to L1 Classic

L1 Classic

T4S

Introduction

You can connect the T4S ToneMatch mixer to the L1 Classic or L1 Model I, just as you would a T1 ToneMatch Audio Engine. You'll need a ToneMatch Power Supply

T4S ToneMatch mixer to one L1 Classic/L1 Model I system

There's a slight difference because there are two 1/4 inch (6.3 mm) output jacks on the T4S for Left and Right Outputs.

You've got two ways to handle this:

1. Pan all your inputs to one side (e.g. Right) and connect the T4S Right output to the L1® Classic Channel 3 (try setting the level to about 4)
   
   
   
   OR
   
2. Leave your inputs panned to center (the default setting), and connect
   • T4S Left output to the L1 Classic/L1 Model I Channel 3
     try setting the level to about 4
   • T4S Right output to the L1 Classic/L1 Model I Channel 4
     try setting the level to about 4

When using a T1 ToneMatch Audio Engine or T4S ToneMatch mixer with the L1® Classic, you don't need to use the R1 Remote.

T4S ToneMatch mixer to two L1 Classic/L1 Model I systems

To run a T4S ToneMatch mixer with two L1 Model I or L1 Classic

On the T4S ToneMatch mixer Pan your inputs left and right as required, but for best results, pan your inputs to one side or the other, but not up the middle

• T4S ToneMatch mixer Left output to the Left L1 Classic/L1 Model I Channel 3
  try setting the level to about 4
• T4S ToneMatch mixer Right output to the Right L1 Classic/L1 Model I Channel 3
  try setting the level to about 4

When using a T1 ToneMatch Audio Engine or T4S ToneMatch mixer with the L1® Classic, you don't need to use the R1 Remote.

---