Template:T1 ToneMatch® Audio Engine to Two L1®s: Difference between revisions
m trim setting for analog input |
|||
| Line 29: | Line 29: | ||
</td></tr> | </td></tr> | ||
</table> | </table> | ||
==== Model II Analog input trim (volume, or gain) control ==== | |||
There is a trim control for the analog input. | |||
[[Image:Model II Analog Input Trim.png]] | |||
# Set the '''Trim''' control on the power stand to the 0 (zero) position. | |||
# Connect the T1 Master Output to the Analog Input using a 1/4 inch (6mm) Tip-Ring-Sleeve cable | |||
# Adjust the volume of the audio source to the maximum output without distortion. | |||
# While playing the source, increase the '''Trim''' level so that the '''Signal/Clip''' indicator glows green or yellow. | |||
# If the '''Signal/Clip''' indicator glows red, decrease the '''Trim''' level so that it glows only green or yellow. | |||
[[Image:Model II Analog Input Level Green.png|Model 1S Analog Input]] | |||
Set the input trim to 10:00 - 11:00 o'clock to get results similar to the other L1® connected through the ToneMatch port. | |||
==Stereo == | ==Stereo == | ||