Stereo to Mono Conversion: Difference between revisions

Revision as of 21:08, 15 February 2009 view source ST (talk \| contribs) Bureaucrats, Interface administrators, Administrators 20,161 edits mNo edit summary ← Older edit		Revision as of 21:19, 15 February 2009 view source ST (talk \| contribs) Bureaucrats, Interface administrators, Administrators 20,161 edits mNo edit summary Newer edit →
Line 8:		Line 8:

	Here is the rule: Outputs are low impedance and must only be connected to high impedance inputs -- never, never tie two outputs directly together -- never. If you do, then each output tries to drive the very low impedance of the other, forcing both outputs into current-limit and possible damage. As a minimum, severe signal loss results.		Here is the rule: Outputs are low impedance and must only be connected to high impedance inputs -- never, never tie two outputs directly together -- never. If you do, then each output tries to drive the very low impedance of the other, forcing both outputs into current-limit and possible damage. As a minimum, severe signal loss results.

	Monoing Your Low End		Monoing Your Low End