Feedback / Microphone: Difference between revisions

m Feedback/Microphone moved to Feedback / Microphone: naming convention
merged content with Microphone Feedback
Line 8: Line 8:
</tr></table>
</tr></table>


Here are some notes about feedback. Rather than sending you following links, I've just put things that seemed relevant below.


== Before Anything Else ==
== Gain Staging ==
Check your gain setup. Take 2 minutes to watch the video (click Steve's picture above). If you are using an L1™ Classic or L1™ Model I follow the instructions exactly as Steve says. For other gear, the principles are still applicable.  
Take two minutes to watch this video by clicking on the picture below.
 
* If you are using an {{Classic}} or {{Model I}} follow the instructions exactly as shown in the video.
* If you are using the {{T1}}, the principles are the same as shown on the video: simply substitute the trim on the T1 for the trim on the Classic or Model I. {{T1 icon}}


If you are using effects, remove them from the signal chain until you can get sufficient [[Gain Before Feedback|gain before feedback]] to get performance level volume. Then add the effects back into the signal chain (one at a time) so you can be aware of the individual impacts that each effect is having on feedback.   
If you are using effects, remove them from the signal chain until you can get sufficient [[Gain Before Feedback|gain before feedback]] to get performance level volume. Then add the effects back into the signal chain (one at a time) so you can be aware of the individual impacts that each effect is having on feedback.   


== Notes from {{Bose}} ==
{{Get Plugged In Microphone}}
=== My vocal microphone keeps encountering feedback. Is there anything I can do to stop it? ===
== Techniques For Reducing Feedback ==
From  the Official Product Troubleshooting Page <!-- TODO fix this link --><ref>[http://www.bose.com/controller?event=VIEW_STATIC_PAGE_EVENT&url=/musicians/support/troubleshooting.jsp&ck=0#feedback  Official Product Troubleshooting Pages]</ref>.
* If you are using vocal effects like reverb, chorus or delay, turn them off until you can get sufficient [[Gain Before Feedback|gain before feedback]] to get performance level volume. Then add the effects back into the signal chain (one at a time) so you can be aware of the individual impacts that each effect is having on feedback.
 
* Orient the microphone so that it is not pointing directly at your Cylindrical Radiator™ loudspeaker. It’s best when your system is not directly behind you- give greater than 5 feet distance between you and your system.
* Try using a “close-miking” technique to increase the gain at the microphone and to reduce unwanted stage sound.
* Use the HIGH tone control knob for the microphone channel carefully. Feedback could occur when this is set too high.
* Upgrade your power stand to newer software that offer a high gain preset. see: Software Upgrading (This covers firmware update and Version 2.0 [[Presets/Model I and Classic|Presets]])
* If using a vocal effects processor, make sure that it is not contributing to the feedback problem.
* If stand -mounting a directional microphone, tilt the microphone up ten or twenty degrees off the horizon so that it is less sensitive to direct sound from the speakers.
* Try a different microphone such as a directional mic. Hypercardioid microphones work well with the system.
 
=== How do I control feedback that I may get when using microphones? ===
From  the Official Product FAQs <ref>[http://www.bose.com/controller?event=VIEW_STATIC_PAGE_EVENT&url=/musicians/support/product_faqs.jsp&ck=0#question40 Official Product FAQs]</ref>.  


Techniques that control feedback with a conventional system help with the Personalized Amplification System™ approach also.
* '''Get close to the microphone''' when you want to be loud. No other technique has a big an impact on feedback. Each halving of distance is approximately another 6 dB of [[Gain Before Feedback|gain before feedback]]. This relationship in physics is known as the [[Inverse Square Law]]. This means that the difference between working a microphone at 2 inches, and 1/4 inch is 18 dB, which is more than twice as loud. While good mic technique often involves "working" the microphone at different distances, singers must be mindful of the fact that small changes in distance from the mouth result in very dramatic changes in sound level.


* Get close to the microphone. No other technique has a big an impact on feedback. Each halving of distance is approximately another 6 dB of gain before feedback. This means that the difference between working a microphone at 2 inches, and 1/4 inch is 18dB!
[[Image:Ferrin_eat_mic.jpg|Charlie Ferrin at Bose: Nov. 9, 2007]]


* Use a directional microphone. Hypercardioid is better than cardioid, which is way better than omnidirectional. All sound waves impinging on the microphone from a direction other than the intended signal is "noise" and will lower the threshold of feedback.
* Use a directional microphone. Hypercardioid is better than cardioid, which is better than omnidirectional. All sound waves impinging on the microphone from a direction other than the intended signal is "noise" and will lower the threshold of feedback.


* Use as few open microphones as possible. When a microphone is not in use, turn it off.
* Use as few open microphones as possible. When a microphone is not in use, if possible, turn it off.


* When stand mounting a directional microphone, tilt the microphone up ten or twenty degrees off the horizon so that it is less sensitive to direct sound from the speakers.
* When stand mounting a directional microphone, tilt the microphone up ten or twenty degrees off the horizon so that it is less sensitive to direct sound from the speakers.


* Use the HIGH tone control knob for the microphone channel carefully. Feedback could occur when this is set too high.
[[Image:MicGoodBad.gif]]


* Use the high-frequency tone control for the microphone channel carefully. Feedback could occur when this is set too high.


== Microphone on a Stand ==
* Wherever possible, acoustic instruments should use pickups instead of microphones.  Pickup systems provide much higher [[Gain Before Feedback|gain before feedback]] than microphones. <br />Using pickup can overcome the struggle to keep a consistent and close distance between the microphone and an instrument. Also, an instrument can be a source of feedback as it resonates with the amplified sound.
Here's a sketch of setting up a microphone on stand.


[[Image:MicGoodBad.gif]]
* Another (low priority) design guide-line could be to keep open microphones as far apart as possible. Neighboring systems with open microphones can mutually decrease gain-before-feedback




== Other general notes ==


* All players should be playing / singing through the L1™ System closest to them
=== Techniques specific to the {{L1 family}} ===
* Every doubling of distance between the microphone and the singer reduces gain-before-feedback by a factor of 4. The difference between 1/2 inch and an inch can be significant.
* All players should be playing / singing through the {{L1}} closest to them.
* Wherever possible "acoustic" instruments should use pickups instead of microphones.  This is important because many players find it a struggle to keep a consistent and close distance between the microphone and their instrument. Also, an instrument can be a source of feedback as it resonates with the amplified sound.
* If you are using a {{T1}} it is often possible to use the parametric EQ section to notch the frequency that is causing feedback. You can find details in the article: [[Using the T1® to Control Microphone Feedback]]
* Another (low priority) design guide-line could be to keep open microphones as far apart as possible. Neighboring systems with open microphones can mutually decrease gain-before-feedback




Line 77: Line 66:
- [http://bose.infopop.cc/eve/forums/a/ga/ul/5711082304/us_pro_mics_for_music_sound_ea.pdf  alternate source for above]
- [http://bose.infopop.cc/eve/forums/a/ga/ul/5711082304/us_pro_mics_for_music_sound_ea.pdf  alternate source for above]


[[User:ST|ST]] 15:46, 22 August 2006 (GMT-7)
 
----
----
<references/>
<references/>