T1 ToneMatch® Audio Engine / Routing for Effects: Difference between revisions
m first ed |
m Foot Switch to Mute Effects |
||
| Line 12: | Line 12: | ||
*Now use the FX Mute buttons for Channels 1 and 2 to set which banks of effects will be used | *Now use the FX Mute buttons for Channels 1 and 2 to set which banks of effects will be used | ||
**Channel 1 only | **Channel 1 only | ||
**Channel 2 only<br> | **Channel 2 only<br> | ||
**Channel 1 and Channel 2 in parallel<br> | **Channel 1 and Channel 2 in parallel<br> | ||
== Serial Effects<br> == | == Serial Effects<br> == | ||
If you want to run some effects and then add more effects in series then take the output of one or more {{T1}} Channels to the Aux Output, then take the Aux Output and use that as the input to another T1® Channel<br> | If you want to run some effects and then add more effects in series then take the output of one or more {{T1}} Channels to the Aux Output, then take the Aux Output and use that as the input to another T1® Channel<br> | ||
Assume that you are using Channel 1 as the input where you want to do this:<br> | Assume that you are using Channel 1 as the input where you want to do this:<br> | ||
*Set the effects that you want on Channel 1 | |||
*Set the '''Aux''' tap to '''Pre''' | *Set the effects that you want on Channel 1 | ||
*Set the '''Aux''' tap to '''Pre''' | |||
*Take a ¼ inch jack cable from the Aux Out to Channel 2 input | *Take a ¼ inch jack cable from the Aux Out to Channel 2 input | ||
*Apply effects that you want applied to the output of Channel 1 | *Apply effects that you want applied to the output of Channel 1 | ||
*Now use the FX Mute buttons for Channels 1 and 2 to set which banks of effects will be used | *Now use the FX Mute buttons for Channels 1 and 2 to set which banks of effects will be used | ||
**Channel 1 only | **Channel 1 only | ||
**Channel 2 only<br> | **Channel 2 only<br> | ||
**Channel 1 and Channel 2 in series<br> | **Channel 1 and Channel 2 in series<br> | ||
<br> | == Foot Switch to Mute Effects<br> == | ||
From Andy-at-Bose UK<br> | |||
<blockquote> | |||
First up hook up your vocal mic to, say, Channel 1 on the T1®. | |||
Next take a jack lead and connect it to the PRE AMP out on Channel 1. | |||
Take this lead and run it through either a keyboard style volume pedal or a make or break style footswitch. | |||
Run the signal from the pedal/footswitch into another T1® channel and set this channel up with the chosen vocal effects but make them 100% effect. Adjust the effected channel volume to get the desired blend of dry vocal to effected vocal. | |||
The pedal/footswitch will determine how much or if any signal will go to channel 2 and therefore whether or not an effect is added.<br> | |||
</blockquote> | |||
[http://bose.infopop.cc/eve/forums/a/tpc/f/8221072574/m/5991023595?r=9991094595#9991094595 Original Post]<br> | |||
<br> | |||
<br> | |||
This article is a stub. Please help us if you can by expanding it. | This article is a stub. Please help us if you can by expanding it. | ||