L1® Model II: Difference between revisions
m == Start Up / Cycle Time == |
== No Speakers Attached == |
||
| Line 15: | Line 15: | ||
== FAQs == | == FAQs == | ||
NOTE: these will be moved to a new page when there are more of them. | NOTE: these will be moved to a new page when there are more of them. | ||
== Start Up / Cycle Time == | == Start Up / Cycle Time == | ||
| Line 46: | Line 47: | ||
* Bass line out | * Bass line out | ||
: Post-DSP bass signal output. Accepts 1/4" TRS phone cable. Use to connect PackLite® amplifier with up to two additional bass modules. Can also be used to connect powered subwoofer or additional amplification system. | : Post-DSP bass signal output. Accepts 1/4" TRS phone cable. Use to connect PackLite® amplifier with up to two additional bass modules. Can also be used to connect powered subwoofer or additional amplification system. | ||
== No Speakers Attached == | |||
If you want to record using USB without using the {{L1CR}} or {{B1}} ... | |||
You can certainly run the L1 with all, some, or none of the speakers connected. With no speakers connected it will happily serve as a big power supply for the T1. You are in no way risking damage to the unit by doing this.<ref>MikeZ-at-Bose talks about [http://bose.infopop.cc/eve/forums?a=tpc&f=3976055944&m=2261013484&r=7911053484#7911053484 Using the L1™ Model II Power Stand without any speakers attached]</ref> | |||
== Articulated Array® == | == Articulated Array® == | ||