T1 ToneMatch® Audio Engine: Difference between revisions

m formatting
move Aux Out section to separate article to be transcluded back here.
Line 19: Line 19:
</td></tr></table>
</td></tr></table>


== Related Documents ==
== Documentation ==
{{:L1™ Model II Documentation}}
{{:L1™ Model II Documentation}}
== Aux Output ==
{{:T1 ToneMatch™ Audio Engine/Aux}}


== Effects ==
== Effects ==
Line 72: Line 75:
{{:T1 ToneMatch™ Audio Engine/USB}}
{{:T1 ToneMatch™ Audio Engine/USB}}


== Aux Output ==
{{:T1 ToneMatch™ Audio Engine/Aux}}
The output of any of the Channels 1, 2, 3, 4/5 can be sent to the Aux out. Options:
* With or without ToneMatch™ Presets
* With or without Effects (except Reverb)
* Pre / Post the individual Channel volume controls.
 
=== No Reverb on Aux ===
Q: Why is there no Reverb on the Aux output of the {{T1}}?
 
A: Hilmar-at-Bose writes<ref>Hilmar-at-Bose writes about [http://bose.infopop.cc/eve/forums/a/tpc/f/7521050644/m/4091082864?r=8551095774#8551095774 No Reverb on Aux]</ref>
: The T1 has lots of different effects units and normally they are unique to each channel. That means that the T1 has 4 individual dynamic processors, 4 modulators (chorus flanger, phaser, etc.) , 4 EQs, 4 delay processors, etc. The only exception is the reverb, which is shared by all channels. <br />
:The AUX is also a per-channel control. That means if you turn up the AUX of channel, you expect to hear signals from channel 1 and only from channel 1. However, the output of the reverb processor contains the reverb portions of all 4 channels. If we add that to the Aux, you'd hear the reverb portions of all 4 channels and not only the channel that you are interested in. In most cases, this is probably not what you want.<br />
:If you are familiar with conventional mixing consoles, you will find that the situation is quite similar. You can only route to an AUX output effects that are specific to a channel (normally these would be connected to the insert loop of this channel). The "shared" effects typically come into the board through an AUX return, which is not channel specific.
 
The discussion continues in the [http://bose.infopop.cc/eve/forums/a/tpc/f/7521050644/m/4091082864?r=8551095774#8551095774 Message Board]
 
== Cables  ==
== Cables  ==
=== From T1 to Model II ===
=== From T1 to Model II ===