Kemper Profiler: Difference between revisions

Line 70:

Connect the Profiler Main Output to the ToneMatch mixer (since the ToneMatch mixer is the input to the FOH (Front of House)).

* XLR connection. ~~That~~ is preferable ~~when you have cable runs in excess of 20 feet (six meters).~~

* XLR connection. This is a balanced connection and it is preferable

* {{1/4 TS}} Use a 1/4 (6.3 mm) Tip-Sleeve cable.

* {{1/4 TS}} Use a 1/4 (6.3 mm) Tip-Sleeve cable. Avoid using this connection when you have cable runs in excess of 20 feet (six meters)

;Profiler Main Outputs:These are your main stereo outputs. Use these outputs to connect to a mixing desk in a recording studio, or to the front-of-house mixer in a live situation. These outputs deliver the entire Rig: amp, cabinet, and all effects. You have a choice of XLR (balanced) or quarter-inch TS-jacks (unbalanced). The XLR outputs are protected against 48V phantom power fed by a mixing desk. However, you should avoid feeding phantom power into the PROFILER if you want the best audio quality. Like all inputs and outputs, it offers a ground lift to prevent a loop hum.

Source: Kemper Main Manual

==== Settings ====

In the Profile Output section, page 1, Set Main Output to Master Mono (or Master Stereo if you are running two L1 systems).

@@ Line 70: / Line 70: @@
 Connect the Profiler Main Output to the ToneMatch mixer (since the ToneMatch mixer is the input to the FOH (Front of House)).
 <section begin=MainOut />
-* XLR connection. That is preferable when you have cable runs in excess of 20 feet (six meters).
+* XLR connection. This is a balanced connection and it is preferable
-* {{1/4 TS}} Use a 1/4 (6.3 mm) Tip-Sleeve cable.
+* {{1/4 TS}} Use a 1/4 (6.3 mm) Tip-Sleeve cable. Avoid using this connection when you have cable runs in excess of 20 feet (six meters)
 ;Profiler Main Outputs:These are your main stereo outputs. Use these outputs to connect to a mixing desk in a recording studio, or to the front-of-house mixer in a live situation. These outputs deliver the entire Rig: amp, cabinet, and all effects. You have a choice of XLR (balanced) or quarter-inch TS-jacks (unbalanced). The XLR outputs are protected against 48V phantom power fed by a mixing desk. However, you should avoid feeding phantom power into the PROFILER if you want the best audio quality. Like all inputs and outputs, it offers a ground lift to prevent a loop hum.
 Source: Kemper Main Manual
 <section end=MainOut />
 ==== Settings ====
 In the Profile Output section, page 1, Set Main Output to Master Mono (or Master Stereo if you are running two L1 systems).