Half Stack: Difference between revisions - Bose Portable PA Knowledge

Line 7:

</noinclude>

;Note - If you are using a Model II, the following applies if you are using one or two B1s attached directly to the L1® Power Stand

Notes from [http://bose.infopop.cc/eve/forums/a/tpc/f/3976055944/m/4051073184?r=8781024184#8781024184 MikeZ-at-Bose]

Line 12:

Line 15:

:The easiest way to 'get through the gig' is to simply remove the top section and play through the bottom only. To balance out your sound in this mode, plug a cable into the 'bass line out' (don't connect it to anything).

:If course you lose a lot of performance from the system, but the show will go on.

:Of course you lose a lot of performance from the system, but the show will go on.

[http://bose.infopop.cc/eve/forums/a/tpc/f/3976055944/m/4051073184?r=8781024184#8781024184 MikeZ-at-Bose]

Line 27:

Line 30:

:Here in Boston, lots of the Irish pubs have really low ceilings, but luckily they also have sturdy tables :-) BUT, be really, really careful. I stand and try to knock a table over before I put my 1/2 L1 on it. If at all in doubt leave it on the ground.

;Note - if you are using a B2 connected directly to your L1® Model II Power Stand

You can still run your system with only the lower half of the Cylindrical Radiator® but plugging in a ¼ inch jack cable to the Bass Line Out will not affect the output to the B2. You will likely want to set the B2 Bass Level switch to the (-) minus position, and turn down the bass at the source ({{T1}} or mixer).

----

@@ Line 7: / Line 7: @@
 </noinclude>
+;Note - If you are using a Model II,  the following applies if you are using one or two B1s attached directly to the L1® Power Stand
 Notes from [http://bose.infopop.cc/eve/forums/a/tpc/f/3976055944/m/4051073184?r=8781024184#8781024184  MikeZ-at-Bose]
@@ Line 12: / Line 15: @@
 :The easiest way to 'get through the gig' is to simply remove the top section and play through the bottom only. To balance out your sound in this mode, plug a cable into the 'bass line out' (don't connect it to anything).
-:If course you lose a lot of performance from the system, but the show will go on.
+:Of course you lose a lot of performance from the system, but the show will go on.
 [http://bose.infopop.cc/eve/forums/a/tpc/f/3976055944/m/4051073184?r=8781024184#8781024184  MikeZ-at-Bose]
@@ Line 27: / Line 30: @@
 :Here in Boston, lots of the Irish pubs have really low ceilings, but luckily they also have sturdy tables :-) BUT, be really, really careful. I stand and try to knock a table over before I put my 1/2 L1 on it. If at all in doubt leave it on the ground.
+;Note - if you are using a B2 connected directly to your L1® Model II Power Stand
+You can still run your system with only the lower half of the Cylindrical Radiator&reg; but plugging in a &frac14; inch jack cable to the Bass Line Out will not affect the output to the B2. You will likely want to set the B2 Bass Level switch to the (-) minus position, and turn down the bass at the source ({{T1}} or mixer).
 <noinclude>
 ----