T1 ToneMatch® Audio Engine: Difference between revisions

Line 130:

For these conditions:

*T1 going into ~~model~~ I/Classic into Ch 3/4

*{{T1 nl}} going into {{Model I nl}}/{{Classic nl}} into Channel 3/4

*balanced OR unbalanced 1/4" cable

*remote unplugged, OR, master volume on remote at 12 o clock

*proper gain staging required on the T1 itself

*proper gain staging required on the T1® itself

I'm going to revise the original recommendation of '''2''' for Ch 3/4 to '''3''' - under the above conditions.

This will give you the same gain going into the L1 Classic~~/model I~~ as if you were going through the digital ethercon input on a ~~model~~ II.

This will give you the same gain going into the {{Model I nl}}/{{Classic nl}} as if you were going through the digital ethercon input on a {{Model II}}.

If you are using the remote on your M1/CL, then you will need to compensate a bit. If you running the remote master volume at max, then stick with '''2'''on Ch 3/4. I would recommend against running the master volume below 12 o'clock when using a T1.

If you are using the remote on your {{Model I nl}}/{{Classic nl}}, then you will need to compensate a bit. If you running the remote master volume at max, then stick with '''2'''on Ch 3/4. I would recommend against running the master volume below 12 o'clock when using a T1®.

@@ Line 130: / Line 130: @@
 For these conditions:
+{{Classic icon}}{{Model I icon}}
-*T1 going into model I/Classic into Ch 3/4
+*{{T1 nl}} going into {{Model I nl}}/{{Classic nl}} into Channel 3/4
 *balanced OR unbalanced 1/4" cable
 *remote unplugged, OR, master volume on remote at 12 o clock
-*proper gain staging required on the T1 itself
+*proper gain staging required on the T1® itself
 I'm going to revise the original recommendation of '''2''' for Ch 3/4 to '''3''' - under the above conditions.
-This will give you the same gain going into the L1 Classic/model I as if you were going through the digital ethercon input on a model II.
+This will give you the same gain going into the {{Model I nl}}/{{Classic nl}} as if you were going through the digital ethercon input on a {{Model II}}.
-If you are using the remote on your M1/CL, then you will need to compensate a bit. If you running the remote master volume at max, then stick with '''2'''on Ch 3/4. I would recommend against running the master volume below 12 o'clock when using a T1.
+If you are using the remote on your {{Model I nl}}/{{Classic nl}}, then you will need to compensate a bit. If you running the remote master volume at max, then stick with '''2'''on Ch 3/4. I would recommend against running the master volume below 12 o'clock when using a T1®.
 <section end=InputSettingNow3 />