T1 ToneMatch® Audio Engine with Compact for Karaoke: Difference between revisions

← Older edit

VisualWikitext

@@ Line 4: / Line 4: @@
 This is broken down into four sections:
-# Connecting the {{T1}} to the {{Compact}}
+# [[{{PAGENAME}}#T1 ToneMatch® Audio Engine to L1® Compact|Connecting the T1® to the Compact]]
-# Gain Staging {{T1}} Channels 1,2,3 for microphones.
+# [[{{PAGENAME}}#Gain Staging T1 ToneMatch® Audio Engine Channels 1,2,3 for Vocals|Gain Staging T1® Channels 1,2,3 for Vocal microphones]]
-# Gain Staging {{T1}} Channel 4/5 for background music.
+# [[{{PAGENAME}}#Gain Staging T1 ToneMatch® Audio Engine Channel 4/5 for Music Tracks|Connecting the T1® for background music]]
-# Setting Volume controls.
+# [[{{PAGENAME}}#Controlling the Volume|Controlling the Volume]]
+If you have questions or comments about this article please post a message in the [http://bose.infopop.cc/eve/forums/a/tpc/f/867107664/m/7110034086 Bose Message Board discussion for this article]. Thank you.
 </td>
@@ Line 70: / Line 72: @@
 == Gain Staging {{T1}} Channel 4/5 for Music Tracks ==
-{{:T1 ToneMatch® Audio Engine / Gain Staging / DJ}}
+These instructions apply if you are using
+* a DJ Console or
+* an analog source for backing tracks
+Note: If you are using a stereo source use {{T1}} Channel 4/5 using the Analog Inputs on the back. Note: If you are connecting by [[USB]] you do not have to set the trim control. When connecting by USB the trim light will be inactive.
+[[Image:T1 Channel 45.png]]
+This is typically a one-time operation. You can do this in silence until the last stage where you bring up the Master Volume.
+Do this with the T1® Master Volume all the way off, and the Channel volume all the way off. You do not need to hear the music to set the trim.
+[[Image:T1 All Off.png|596px]]
+Your first adjustment for any input to your {{T1}} is the Trim setting. The exact position of the Trim will vary depending on signal strength of your input source. The correct setting for any particular source may be different from your other sources.
+[[Image:T1TrimPots.png|T1® Trim Pots]]
+=== Set Up Your Source ===
+Set up your DJ console to the highest output level you will use during a show - that is ⇒ the maximum, highest output recommended in the DJ console manual. Make sure that there is no sign of clipping.
+Play some music. There will be no sound. That's okay for now.
+=== Set Input Trim ===
+Turn the Trim setting up until the Trim Light is solid green with occasional flickers of yellow. Use the Trim lights as your guide. (The exact position of the Trim knob is not important).
+[[Image:T1Trimlights45OK.gif|T1® Trim Pots]]
+If you see flickers of red (below), turn the Trim down. You are definitely nearing or in compression. Turn the Trim down until there are no red flickers.
+[[Image:T1Trimlights45No.gif|T1® Trim Pots]]
+That's it for setting the trim for that Channel and you should not need to change it unless you change DJ Consoles.
+Bring up the volume on Channel 4/5 to 12:00 o'clock.
+[[Image:T1 Channel45 12oclock.png]]
+Now you can bring up the Master Volume to the required volume for the situation.
+[[Image:T1 Channel45 Master 12oclock.png]]
+:A really helpful feature on the T1 is to go to the Prefs/Output Level menu, and see where you are relative to maximum output.
+[[Image:T1 Prefs Output Levels Master.png]]
 == Controlling the Volume ==
+If you have set the T1® Trim Controls as described above, you should not have to change them again unless you change microphones or the source for Channel 4/5.
+Start with all of the T1® Volume Controls at zero.
+Connect the T1® Master output to the Compact Channel 2 volume straight up (12:00 o'clock) for good results. You can turn it up higher, but if you see the light on the Compact flickering red, turn down the volume on the Compact.
+;Overview
+: Use the T1® Channel 1, 2, 3, 4/5 Volume controls to set the relative volume between the vocals and the background music.
+: Use the T1® Master Volume to control the overall volume in the room.
+;Detailed Instructions
+# Play some music through T1® Channel 4/5.
+# Turn up Channel 4/5 Volume to 12:00 o'clock
+# Turn up the Master Volume to a comfortable listening level.
+# Turn up Channel 1 (or 2 or 3) Volume and sing.
+#* Set the relative volume between the microphone and the music to get a good sounding mix so you can hear the vocals well above the music.
+#* If you have more than one microphone bring up the Channel volume for a suitable mix.
+# Adjust the Master Volume for the overall volume required.
 ----