Bose Portable PA Knowledge

Template:T1 ToneMatch® Audio Engine to Two L1®s: Difference between revisions

ST (talk | contribs)
Bureaucrats, Interface administrators, Administrators
20,075 edits
VisualWikitext
m New page: <noinclude> Usage: <pre> {{Two T1®s with Two L1®s |Model=Model II }} </pre> </noinclude> <big> Please note: Bose recommends that if you have two {{{Model|Model 1S}}} systems using the ...
 
mNo edit summary
 
(5 intermediate revisions by the same user not shown)
Line 2: Line 2:
Usage:
Usage:
<pre>
<pre>
{{Two T1®s with Two L1®s
{{T1 ToneMatch® Audio Engine to Two L1®s
|Model=Model II
|Model=Model II
}}
}}
</pre>
</pre>
</noinclude>
</noinclude>
{{T1 icon}}{{Model 1S icon}}{{Model II icon}}
<big>   
<big>   
Please note: Bose recommends that if you have two {{{Model|Model 1S}}} systems using the same source, that you place the {{{Model|Model 1S}}} systems at least 20 feet apart (6 meters). This is to avoid  [[Multiple_Source_Interference|Multiple Source Interference]]   
Please note: Bose recommends that if you have two {{{Model|Model 1S}}} systems using the same source, that you place the {{{Model|Model 1S}}} systems at least 20 feet apart (6 meters). This is to avoid  [[Multiple_Source_Interference|Multiple Source Interference]]   
Line 28: Line 29:
</td></tr>
</td></tr>
</table>
</table>
==== Model II Analog input trim (volume, or gain) control  ====
There is a trim control for the analog input.
[[Image:Model II Analog Input Trim.png]]
# Set the '''Trim''' control on the power stand to the 0 (zero) position.
# Connect the T1 Master Output to the Analog Input using a 1/4 inch (6mm) Tip-Ring-Sleeve cable
# Adjust the volume of the audio source to the maximum output without distortion.
# While playing music through the T1®, increase the '''Trim''' level so that the '''Signal/Clip''' indicator glows green or yellow.
# If the '''Signal/Clip''' indicator glows red, decrease the '''Trim''' level so that it glows only green or yellow.
[[Image:Model II Analog Input Level Green.png|Model 1S Analog Input]]
Set the input trim to 10:00 - 11:00 o'clock to get results similar to the other L1® connected through the ToneMatch port.
==Stereo ==
{{:T1 ToneMatch® Audio Engine / Stereo Output to Two L1®s}}
----
----
[[Category:T1]]
[[Category:T1]]
Retrieved from "https://boseperformer.com/Template:T1_ToneMatch®_Audio_Engine_to_Two_L1®s"