|
|
| (4 intermediate revisions by the same user not shown) |
| Line 4: |
Line 4: |
|
| |
|
| |RightBody = | | |RightBody = |
| | <!-- |
| | {{Philosophy of Simplicity}} |
| | --> |
| === The Simplest Thing That Could Possibly Work === | | === The Simplest Thing That Could Possibly Work === |
| There are many ways to connect a mixer to a Bose L1 Pro, and just as many ways for things to go wrong. Different mixers, different cables, different output levels, different channel settings, and different ToneMatch presets create a huge number of permutations. | | There are many ways to connect a mixer to a Bose L1 Pro, and just as many ways for things to go wrong. Different mixers, different cables, different output levels, different channel settings, and different ToneMatch presets create a huge number of permutations. |
| Line 168: |
Line 171: |
|
| |
|
| == FAQ == | | == FAQ == |
| === Why shouldn’t I use XLR cables from my mixer into Channels 1 or 2? ===
| | {{Mixer to L1 Pro FAQ}} |
| You might be able to, but it often leads to problems.
| |
|
| |
|
| ==== 1. Some mixers can output mic‑level on XLR — most cannot ====
| |
| If your mixer allows switching its XLR outputs from Line to Mic, then it may work.
| |
| But this is uncommon.
| |
|
| |
| Using XLR → ¼″ (6.3 mm) Tip-Ring-Sleeve into Channel 3 is far more reliable.
| |
|
| |
| ==== 2. Most mixer XLR outputs are line‑level, which is a poor match for the L1 Pro’s mic‑level XLR inputs ====
| |
| This mismatch can cause:
| |
|
| |
| Input clipping
| |
|
| |
| Harsh distortion
| |
|
| |
| Unpredictable behavior
| |
|
| |
| ==== 3. You can sometimes “make it work,” but it’s not ideal ====
| |
| You might avoid clipping by:
| |
|
| |
| Turning down the mixer output
| |
|
| |
| Turning down the L1 Pro channel volume
| |
|
| |
| However:
| |
|
| |
| Lowering the mixer output reduces signal‑to‑noise ratio (more hiss)
| |
|
| |
| Turning the L1 Pro channel knob very low gives almost no usable range
| |
|
| |
| Volume may jump from too quiet → too loud with tiny adjustments
| |
|
| |
| ==== 4. Channel 3 avoids all of these issues ====
| |
| Channel 3 is designed for line‑level sources and provides:
| |
|
| |
| * Proper level matching
| |
| * No ToneMatch presets
| |
| * No Reverb
| |
| * No DSP gain steps
| |
| * Lower input sensitivity (less likely to clip/distort)
| |
| * Full +24 dBu headroom
| |
| * Predictable behavior
| |
|
| |
| This is why the recommended method is:
| |
|
| |
| Mixer mono out → XLR‑to‑Tip-Ring-Sleeve → L1 Pro Channel 3
| |
|
| |
|
| == References == | | == References == |
| {{L1 Pro Technical Data Sheets}} | | {{L1 Pro Documentation}} |
| ---- | | ---- |
|
| |
|