Template:Sub2 with Sub1: Difference between revisions
mNo edit summary |
mNo edit summary |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
You can use a Sub1 and Sub2 together. The connection will be L1 Pro32 to Sub2 to Sub1 | You can use a Sub1 and Sub2 together. The connection will be L1 Pro32 to Sub2 to Sub1 | ||
There are two options. Either is fine. Choose the one you prefer. | You can stack them or place them side by side. In any arrangement where the grilles fit completely within a 30-inch (75 cm) diameter sphere, your two Subs will act like a single one, only louder. Note: Placing the Subs on either side of the L1 Pro32 power stand does not meet this criteria. | ||
There are two options. Either is fine. Choose the one you prefer. | |||
;Option 1: Same crossover frequency applied to both Sub1 and Sub2 (200—37Hz) | ;Option 1: Same crossover frequency applied to both Sub1 and Sub2 (200—37Hz) | ||
| Line 12: | Line 14: | ||
; Option 2: Crossover frequencies: <br>Sub2: 100—37 Hz <br>Sub1: 200—100 Hz | ; Option 2: Crossover frequencies: <br>Sub2: 100—37 Hz <br>Sub1: 200—100 Hz | ||
# Connect the L1 Pro32 to the Sub2 ( | # Connect the L1 Pro32 Line Out to the Sub2 (with an XLR cable and power the Sub2 with the supplied IEC power cable). | ||
# On the Sub2 set the | # On the Sub2 set the LINE IN EQ to LPF [Low Pass Filter] (this sets the crossover to 100 Hz) | ||
# Connect the Sub2 | # On the Sub2 set the LINE OUT EQ to HPF [High Pass Filter] (this sets the Line Out to send 100 Hz and higher) | ||
# Connect the Sub2 LINE OUT to the Sub1 with an XLR cable and power the Sub1 with the supplied IEC power cable. | |||
# Level - set to 12:00 o'clock on both. If adjustments are necessary - keep the Level Control the same on both Subs | # Level - set to 12:00 o'clock on both. If adjustments are necessary - keep the Level Control the same on both Subs | ||
# Polarity: Plus on both | # Polarity: Plus on both | ||