Template:Bass Line Out: Difference between revisions
mNo edit summary |
mNo edit summary |
||
| (14 intermediate revisions by the same user not shown) | |||
| Line 11: | Line 11: | ||
</noinclude> | </noinclude> | ||
<!-- setup for tables --> | <!-- setup for tables --> | ||
{{Style table.b2}} | |||
__NOEDITSECTION__ | __NOEDITSECTION__ | ||
<noinclude> | <noinclude> | ||
| Line 132: | Line 100: | ||
For 6 B1s you will be 3.5 dB bass heavy, for 8 B1s it'll be 6 dB heavy. | For 6 B1s you will be 3.5 dB bass heavy, for 8 B1s it'll be 6 dB heavy. | ||
== B2 EQ == | |||
{{Bass Line Out Model II Post Firmware 1.4}} | |||
<!-- | |||
=== B2 Bass Module connected to the Bass Module Output (powered output) === | === B2 Bass Module connected to the Bass Module Output (powered output) === | ||
<section begin=Bass Module Output /> | <section begin=Bass Module Output /> | ||
--> | |||
<!-- | <!-- Being investigated with Bose | ||
<strike> --> | |||
If one or two {{B1}}s emulated using resistors across NL4 2+ / 2- pins | Output if no {{B1}}s detected at the Bass Module Output (powered output) the signal at the Bass Line Out is: | ||
* 40-{{{Crossover|180}}} Hz with '''B2 EQ applied''' if you have the current [[L1® Model II Power Stand Firmware Updates]] | |||
** If you do not have the current firmware the signal at the Bass Line Out is: 40-{{{Crossover|180}}} Hz Bandpass (that is: NO B1 EQ) <ref>Hilmar-at-Bose [http://bose.infopop.cc/eve/forums/a/tpc/f/3976055944/m/6121039062?r=9441007562#9441007562 intelligent crossover] <br /> | |||
A) When there are no bass sources attached, lower the crossover and try to get as much bass out of the L1 as is reasonably feasible (110 Hz) in this case<br /> | |||
B) If there are bass sources bring the crossover up to 180 Hz (where the L1 starts to get really efficient) AND adjust the bass gain so that the overall spectral balance is maintained no matter how many bass sources are attached. | |||
</ref> | |||
* The system Crossover for the Cylindrical Radiator®s is {{{Crossover|180}}} Hz | |||
If one or two {{B1}}s is detected or emulated using resistors across NL4 2+ / 2- pins | |||
* 40-{{{Crossover|180}}} Hz with different EQ curves | * 40-{{{Crossover|180}}} Hz with different EQ curves | ||
* The system Crossover for the Cylindrical Radiator®s is {{{Crossover|180}}} Hz | |||
For details on how to do this see: [[Activating B1 EQ Curves]] and [[Using a Different Sub]] | For details on how to do this see: [[Activating B1 EQ Curves]] and [[Using a Different Sub]] | ||
<!-- </strike> --> | |||
<section end=Bass Module Output /> | <section end=Bass Module Output /> | ||
; Note — Operation of the B2 with the Model I/Classic is only supported with the B2 Bass Level Switch set to '''Normal'''. | |||
: See: [[Is the B2 Bass Module Compatible with the L1® Classic or Model I]] | |||
=== Bass Module Output (powered output) === | === Bass Module Output (powered output) === | ||