Mixer / Yamaha / MG124 CX: Difference between revisions
| (One intermediate revision by the same user not shown) | |||
| Line 11: | Line 11: | ||
* Run a line out of the LEFT output to the Model II Power Stand Analog input (cable details below) | * Run a line out of the LEFT output to the Model II Power Stand Analog input (cable details below) | ||
[[Image:YamahaMG124 to Model II Power Stand Analog Input.png]] | [[Image:YamahaMG124 to Model II Power Stand Analog Input.png]] | ||
==== Settings on the L1® Input Panel ==== | |||
Start off with the Input Trim at '''3''' and adjust if necessary so that the Signal/Clip light stays green most of the time. Occasional flickers of yellow are okay. If it is flickering or solid red, turn down the Input Trim. | |||
[[Image:ModelIIInputsForTwoLT1.png]] | |||
==== Cable Details ==== | ==== Cable Details ==== | ||