Mixer / Yamaha / MG124 CX: Difference between revisions

@@ Line 1: / Line 1: @@
-To use a Yamaha MG124 CX Mixer with the {{Model II}}
+<table><tr>
+<td valign="top" width="250">__TOC__</td>
+<td valign="top">To use a Yamaha MG124 CX Mixer with the {{Model II}}
+</td>
+</tr></table>
 ==== Overview ====
 On the mixer
-* pan all the inputs hard LEFT
+* Pan all the inputs hard LEFT
-* run a line out of the LEFT output  to the Model II Power Stand  Analog input (cable details below)
+* Run a line out of the LEFT output  to the Model II Power Stand  Analog input (cable details below)
 [[Image:YamahaMG124 to Model II Power Stand Analog Input.png]]
+==== Settings on the L1® Input Panel ====
+Start off with the Input Trim at '''3''' and adjust if necessary so that the Signal/Clip light stays green most of the time. Occasional flickers of yellow are okay. If it is flickering or solid red, turn down the Input Trim.
+[[Image:ModelIIInputsForTwoLT1.png]]
 ==== Cable Details ====
@@ Line 30: / Line 41: @@
 </td></tr></table>
+=== Documents ===
+* {{Model II}}
+* [http://download.yamaha.com/api/asset/file?language=en&site=countrysite-master.prod.exp.yamaha.com&asset_id=8043 Yamaha MG124CX/MC124 Owner's Manual]
+[[Image:YamahaMG124 Output.png]]
 ----
 [[Category:Mixer]]
 [[Category:Yamaha]]