S1 Pro to L1 Model I - Revision history

ST: Text replacement - "Category:S1" to "Category:S1 Pro"

2019-11-17T02:20:58Z

Text replacement - "Category:S1" to "Category:S1 Pro"

← Older revision		Revision as of 02:20, 17 November 2019
Line 30:		Line 30:

	[[Category:How To]]		[[Category:How To]]
	[[Category:S1]]		[[Category:S1 Pro]]
	[[Category:Model I]]		[[Category:Model I]]
	[[Category:Connections]]		[[Category:Connections]]

	}}		}}

ST: added images

2018-10-20T00:13:57Z

added images

← Older revision		Revision as of 00:13, 20 October 2018
Line 7:		Line 7:
	Connect {{S1}} to {{Model I}}		Connect {{S1}} to {{Model I}}

	You can connect to the S1 Pro system as you would when using it alone. Then run a cable from the S1 Pro Line Out to any of the 1/4" inputs on the L1 Model I. You can use an ordinary Tip-Sleeve instrument cable.		You can connect to the S1 Pro system as you would when using it alone. Then run a cable from the S1 Pro Line Out

			{{S1 Pro Line Out}}


			to any of the 1/4" inputs on the L1 Model I. You can use an ordinary Tip-Sleeve instrument cable.

			[[File:L1 Model I 14 inputs.jpg]]

	If you use the L1 Model I inputs on channels 1 or 2, set the Preset to 00. Set the input trim so that when you are running the S1 Pro at the loudest you will perform, the L1 Model I Signal/OL lights are solid green. Occasional red flickers are okay.		If you use the L1 Model I inputs on channels 1 or 2, set the Preset to 00. Set the input trim so that when you are running the S1 Pro at the loudest you will perform, the L1 Model I Signal/OL lights are solid green. Occasional red flickers are okay.

			[[File:SignalOLLED.png]]

ST: Created article

2018-10-19T23:52:43Z

Created article

New page

If you want to use your {{S1}} as a monitor and use an {{Model I}} as the Front of House system you can connect your microphone and instrument to the {{S1}} and connect the {{S1}} to the {{Model I}}

{{How To

|How To =
Connect {{S1}} to {{Model I}}

You can connect to the S1 Pro system as you would when using it alone. Then run a cable from the S1 Pro Line Out to any of the 1/4" inputs on the L1 Model I. You can use an ordinary Tip-Sleeve instrument cable.

If you use the L1 Model I inputs on channels 1 or 2, set the Preset to 00. Set the input trim so that when you are running the S1 Pro at the loudest you will perform, the L1 Model I Signal/OL lights are solid green. Occasional red flickers are okay.

|Additional Information =

Note: All the 1/4" inputs on the L1 Model I are unbalanced. That means, there's no need or advantage to using a balanced Tip-Ring-Sleeve cable. Also, if you use a 1/4" Tip-Ring-Sleeve to XLR cable into channels 1 or 2, you may find it difficult to do the gain staging because the signal from the S1 Pro may be too hot for the XLR inputs.

|Categories =

[[Category:How To]]
[[Category:S1]]
[[Category:Model I]]
[[Category:Connections]]

}}