PS1 Powerstand Connections/Line Out/Insert - Revision history

ST: Model I and Classic icons, category updates

2007-04-29T07:07:21Z

Model I and Classic icons, category updates

← Older revision		Revision as of 07:07, 29 April 2007
Line 1:		Line 1:
			{{Model I icon}}{{Classic icon}}
	== Line Out from Insert Point ==		== Line Out from Insert Point ==
	* access from the "ring" connection at the Insert Point		* access from the "ring" connection at the Insert Point
Line 13:		Line 14:


	[[~~category~~:L1™ System]]		[[Category:L1™ System]]
	[[~~category~~:PS1 Powerstand]]		[[Category:PS1 Powerstand]]
	[[~~category~~:PS1 Powerstand Connections]]		[[Category:PS1 Powerstand Connections]]
			[[Category:Model I]]
			[[Category:Classic]]

ST: /* Line Out from Insert Point */

2006-11-14T19:15:56Z

Line Out from Insert Point

← Older revision		Revision as of 19:15, 14 November 2006
Line 4:		Line 4:
	* post {{R1}} Channel Level		* post {{R1}} Channel Level

	For Channels One or Two insert a 1/4 inch cable halfway into the Insert jack to get a signal that is controlled by the volume control on the Remote. This is also known as the [[Half Insert]] method. For more information about 1/4 cables see [[TRS\|Tip Ring Sleeve connections]].		For Channels One or Two insert a 1/4 inch cable halfway into the Insert jack to get a signal that is controlled by the volume control on the Remote. This is also known as the [[Half Insert]] method. For more information about 1/4 cables see [[TRS\|Tip Ring Sleeve connections]]. The rectangular box shown below the input panel is a [[DI]], used to output the signal to a console or house system.

	[[Image:PS1LineOutInsert.jpg]]		[[Image:PS1LineOutInsert.jpg]]

ST: first ed

2006-11-14T19:14:26Z

first ed

New page

== Line Out from Insert Point ==
* access from the "ring" connection at the Insert Point
* post trim
* post {{R1}} Channel Level

For Channels One or Two insert a 1/4 inch cable halfway into the Insert jack to get a signal that is controlled by the volume control on the Remote. This is also known as the [[Half Insert]] method. For more information about 1/4 cables see [[TRS|Tip Ring Sleeve connections]].

[[Image:PS1LineOutInsert.jpg]]

----
<references/>

[[category:L1™ System]]
[[category:PS1 Powerstand]]
[[category:PS1 Powerstand Connections]]