L1 Pro32 Half Stack - Revision history

ST at 16:39, 29 August 2021

2021-08-29T16:39:42Z

← Older revision		Revision as of 16:39, 29 August 2021
Line 9:		Line 9:

	:It’s a valid use case to use only the bottom array section. In fact, the EQ automatically adjusts to compensate.<br>[https://www.facebook.com/groups/BoseL1/posts/10159778256657446/?comment_id=10159778526867446&reply_comment_id=10159779126107446 Craig Small - Bose]		:It’s a valid use case to use only the bottom array section. In fact, the EQ automatically adjusts to compensate.<br>[https://www.facebook.com/groups/BoseL1/posts/10159778256657446/?comment_id=10159778526867446&reply_comment_id=10159779126107446 Craig Small - Bose]


			; Half Stack Not Recommended for Small Gigs
			Running only the lower section of the Line Array is a workaround when there isn't enough ceiling clearance to use both sections. For small gigs, turn down the volume on the L1 Pro32, don't run without the top section of the array because
			* You'll need to elevate the system so the array is at ear level for the audience. Otherwise, the sound will be muffled
			* You will reduce your projection over distance. The sound will drop off more over distance.
			* You may need to turn up the volume louder than if you were using the full array. As a result, you increase the likelihood of feedback.

	----		----
	[[Category:L1 Pro]]		[[Category:L1 Pro]]
	[[Category:Half Stack]]		[[Category:Half Stack]]

ST at 02:27, 9 July 2021

2021-07-09T02:27:54Z

← Older revision		Revision as of 02:27, 9 July 2021
Line 3:		Line 3:

	;Yes		;Yes
	~~Notes~~:		:The L1 Pro32 can be used without the upper array. This configuration is useful when a venue ceiling cannot accommodate the height of the L1 Pro32<br>Source: Page 7 of the [[Media:L1 Pro32 Owners Guide.pdf\|L1 Pro32 Owners Guide]]

	* For best results, ensure array is at ear level for listeners		* For best results, ensure array is at ear level for listeners
	* Unlike the L1 Model II, the L1 Pro32 automatically adjusts the level of the bass output to maintain the appropriate spectral balance.		* Unlike the L1 Model II, the L1 Pro32 automatically adjusts the level of the bass output to maintain the appropriate spectral balance.

ST: Created page with ";Can I operate the L1 Pro32 with only the lower section of the line array? : Sometimes there is not sufficient height to use the full array ;Yes Notes: * For best results, en..."

2021-07-09T02:16:40Z

Created page with ";Can I operate the L1 Pro32 with only the lower section of the line array? : Sometimes there is not sufficient height to use the full array ;Yes Notes: * For best results, en..."

New page

;Can I operate the L1 Pro32 with only the lower section of the line array?
: Sometimes there is not sufficient height to use the full array

;Yes
Notes:
* For best results, ensure array is at ear level for listeners
* Unlike the L1 Model II, the L1 Pro32 automatically adjusts the level of the bass output to maintain the appropriate spectral balance.

:It’s a valid use case to use only the bottom array section. In fact, the EQ automatically adjusts to compensate.<br>[https://www.facebook.com/groups/BoseL1/posts/10159778256657446/?comment_id=10159778526867446&reply_comment_id=10159779126107446 Craig Small - Bose]

----
[[Category:L1 Pro]]
[[Category:Half Stack]]