ST: ST moved page L1Â® Model I / FAQ Extension to L1® Model I / FAQ Extension

2017-03-26T22:27:06Z

ST moved page L1Â® Model I / FAQ Extension to L1® Model I / FAQ Extension

← Older revision	Revision as of 22:27, 26 March 2017
(No difference)

ST: first ed

2008-12-24T19:39:17Z

first ed

New page

<noinclude>
This extends the

OFFICIAL FAQ item
=== What is the recommended way to set the gain for a Model I system when using it with a T1 ToneMatch audio engine? ===
* Make sure the power switch on the power stand is in the Off position and the remote control is disconnected 
Note: The remote should be disconnected so that the ToneMatch audio engine solely controls the volume of the {{L1 nl}} system.
* Make sure the ToneMatch audio engine power switch is in the Off position and its power supply is connected
* Set the ToneMatch audio engine master volume control to 0
* Plug one end of a 1/4" phone plug cable (not supplied) into the master output port on the ToneMatch audio engine. Plug the other end of the cable into the line-in jack of channel 3 or 4 on the {{L1 nl}} power stand 
Note: We recommend only connecting to the line inputs of channels 3 and 4 because channel 1 and 2 mic/line inputs have volume controls, equalization and presets that could affect the ToneMatch audio engine's sound and performance.
* Set the line-in level control on the power stand to approximately 2 Note: In some circumstances, it may be necessary to slightly adjust the level of this initial setting to attain the desired gain structure.

----
</noinclude>
'''Note''':

Bose has revised this, and now recommends setting the level control to approximately '''3'''.

=== Input setting recommendation now '''3''' ===
{{#lst:T1 ToneMatch® Audio Engine|InputSettingNow3}}

<noinclude>
----
[[Category:FAQ Extension]]
[[Category:Model I]]
</noinclude>

L1® Model I / FAQ Extension - Revision history

ST: ST moved page L1Â® Model I / FAQ Extension to L1® Model I / FAQ Extension

ST: first ed