View source for Template:ToneMatch Mixer to L1 Model II and L1 Model I

<noinclude>
'''<big>Usage</big>'''

<nowiki>{{</nowiki>'''ToneMatch Mixer to L1 Model II and L1 Model I'''

|'''ToneMatchMixer=''' ''{{T4S}}  or {{T8S}}''

|discussion page = link to forum discussion (optional) e.g. [http://bose.infopop.cc/eve/forums/a/tpc/f/1506041054/m/4440014176 discussion in the Bose Message Board]

<nowiki>}}</nowiki>

Template will render as it appears below this line.

----
</noinclude>

This article describes how you can connect a {{{ToneMatchMixer|{{T4S}}}}} to an {{Model II}} and an {{Model I}}.

=== L1 Model I  ===

Connect one {{{ToneMatchMixer|{{T4S}}}}} 1/4 inch (6 mm) main output to the {{Model I}}/Classic channel 1. Use a {{1/4 TS}}.

With the {{{ToneMatchMixer|{{T4S}}}}} master output around 11:00 o'clock and running some inputs at the maximum you will use in performance, set the {{Model I}}/Classic input trim level so you get solid green lights with occasional flashes of red.

You don't need to use the R1 Remote when you're using the {{{ToneMatchMixer|{{T4S}}}}}.

Set the ToneMatch Preset to 00.

====Questions====

;    Why not use the XLR output on the {{{ToneMatchMixer|{{T4S}}}}} and XLR input on the {{Model I}}
:        The XLR outputs from the T4S are too hot for the XLR inputs on the {{Model I}}
;    Should I use {{1/4 TRS}}s for a balanced connection?
:        No need. The 1/4 inch  (6 mm)  inputs on the L1 Classic are unbalanced. You can use balanced cables but there's no advantage

===L1 Model II===

Connect the one {{{ToneMatchMixer|{{T4S}}}}} {{1/4 TRS}} main output to the L1 Model II Analog Input. Use a {{1/4 TRS}}.

With the T4S master output around 11:00 o'clock and running some inputs at the maximum you will use in performance, set the L1 Model II input trim level so you get solid green lights with occasional flashes of red. This may be different than the setting on the L1 Model I.

====Questions====


;    Why not use the XLR output on the {{{ToneMatchMixer|{{T4S}}}}}
:        This is a matter of convenience. When you use {{1/4 TRS}}s, both ends work in both devices. 
;    Should I use {{1/4 TRS}}s for a balanced connection?
:        Yes. The 1/4 inch  (6 mm) output from the T4S is balanced. The analog input on the L1 Model II is balanced. Use a {{1/4 TRS}} to maintain a balanced connection.
;    How do I balance the relative volume between the two L1 systems?
:        Do this by ear. If you start off with both responding with solid green lights (red flickers are okay), then turn down the one that is too loud.

----
[[Category:T4S]]
[[Category:T8S]]
[[Category:Connections]]