View source for L1® Model I / FAQ Extension

<noinclude>
This extends the 

OFFICIAL FAQ item
=== What is the recommended way to set the gain for a Model I system when using it with a T1 ToneMatch audio engine? ===
* Make sure the power switch on the power stand is in the Off position and the remote control is disconnected<br> 
<i>Note: The remote should be disconnected so that the ToneMatch audio engine solely controls the volume of the {{L1 nl}} system.</i>
* Make sure the ToneMatch audio engine power switch is in the Off position and its power supply is connected
* Set the ToneMatch audio engine master volume control to 0
* Plug one end of a 1/4" phone plug cable (not supplied) into the master output port on the ToneMatch audio engine. Plug the other end of the cable into the line-in jack of channel 3 or 4 on the {{L1 nl}} power stand <br /><i>
Note: We recommend only connecting to the line inputs of channels 3 and 4 because channel 1 and 2 mic/line inputs have volume controls, equalization and presets that could affect the ToneMatch audio engine's sound and performance.</i>
* Set the line-in level control on the power stand to approximately 2 <br /><i>Note: In some circumstances, it may be necessary to slightly adjust the level of this initial setting to attain the desired gain structure.</i> 

----
</noinclude>
'''Note''':
 
Bose has revised this, and now recommends setting the level control to approximately '''3'''.  

=== Input setting recommendation now '''3'''  ===
{{#lst:T1 ToneMatch® Audio Engine|InputSettingNow3}}

<noinclude>
----
[[Category:FAQ Extension]]
[[Category:Model I]]
</noinclude>